Depending on your intended use, you might want to install a keyboard that will work on the touchscreen, if so, carry on to the next step. If your screen came with different coloured jumper wires, ensure that your cables are connected correctly.Īt this stage, you can power up your Pi and the screen should be up and running. Connect the yellow jumper wire to the 3rd pin from the right on the top row.Connect the green jumper wire to the 2nd pin from the right on the top row.Connect the black jumper wire to the 3rd pin from the right on the bottom row.Connect the red jumper wire to the 2nd pin from the right on the bottom row.With the Pi positioned upsidedown, as shown above: Push in the black tabs of the DISPLAY connector to secure the ribbon cable.Insert the display’s ribbon cable into the DISPLAY connector of the PI.Gently pull the black tabs of the Pi’s DISPLAY connector.Mount the Pi on to the back of the screen ensuring that the connector labelled DISPLAY on the PI is on the same side as the ribbon connector on the screen.Connect the green jumper wire to SDA on the screen’s board.Connect the yellow jumper wire to SCL on the screen’s board.Connect the red jumper wire to 5V on the screen’s board.Connect the black jumper wire to GND on the screen’s board.Push the connector’s black tabs back in to secure it.Insert the ribbon cable into the connector with the blue side down.Gently pull out the black tabs of the ribbon cable connector simultaneously.It is recommended that you don’t peel the protecting film off the screen until you’ve finished the assembly to avoid scratching it. ![]() You should start with a Wi-Fi enabled Raspberry Pi with the latest OS installed. ![]() 1 x Official Raspberry Pi 7″ Touch Screen Lcd Get your Pi ready
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |